If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi, im mainly a proquake guy, but for qrack are you supposed to use commands like -dinput or -nofrocemaccel -noforcemparms ? or does qrack not need them
Qrack defaults with 32mb ram allocation,
use m_directinput or m_raw_input 1
m_noforcemparms 1 (if not using either) these will save to your config.cfg and then will be uses each time you start up.
without using any command line options it will use 32mb ram, though you will not need that much. If you use something like -mem 16 then it will drop to that level. But things can run slower or not load-up at all.
Fire up dm3 and then type MEM in the console to see how much "QUAKE" memory you are using. Qrack uses system ram for particles, and enchinced gfx.
Comment